Iranian Journal of Materials Science and Engineering

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

---

Mechanical properties of metals are substantially dependent on the microstructure, which can be controlled by thermo-mechanical parameters such as the temperature, strain and strain rate. Hence, understanding the microstructural evolution of alloys during the hot deformation is crucial for engineering the metal forming processes. The main objective of this work is to present an overview of Cellular Automaton (CA) modeling for predicting the microstructure of alloys during the dynamic recrystallization (DRX) phenomenon. In this review paper, first, overall descriptions about the DRX phenomenon and CA modeling were presented. Then, the CA modeling procedure was compared with similar methods. Meanwhile, related studies in the field of the DRX simulation by using the CA modeling were evaluated. Four main stages of the model were analyzed in terms of the “nucleation”, “growth”, “topological changes” and “texture evaluation” steps. Most important limitations including the calibration sensitivity, limitations in continuous DRX modeling, ignoring microstructural effects on the deformation behavior, limited applications and database as well as repeated results were discussed and then objective suggestions for the further development were provided. Finally, future prospects in CA modeling of DRX were presented in the last section.
 

Keywords: Dynamic recrystallization, Modeling, Cellular automaton, Microstructure

Full-Text [PDF 4992 kb]   (8807 Downloads)    

Add your comments about this article : Your username or Email:

---

---