Volume 13, Issue 2 (June 2016)                   IJMSE 2016, 13(2): 1-9 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Eshghi E, Kadkhodayan M. SHEET ELECTROMAGNETIC FORMING USING CONVEX PUNCH INSTEAD OF CONVAVE DIE. IJMSE 2016; 13 (2) :1-9
URL: http://ijmse.iust.ac.ir/article-1-752-en.html
Abstract:   (18278 Views)

High speed and absence of a precise control over pressure distribution confine sheet Electromagnetic Forming into a die to simple shapes having shallow depth. It is possible to reach a higher depth by using a convex punch instead of a concave die. In this study, sheet Electromagnetic Forming on a punch and sheet Electromagnetic Forming into a die are investigated. The electromagnetic part of the study is investigated analytically and its mechanical part is studied numerically. In order to couple electromagnetic with mechanical parts, no-coupling method is used. The obtained results are verified by comparing the obtained results with previous experimental ones in literature. Rate-dependent and rate-independent hardenings are taken into consideration for the mechanical behavior for material of AAl1050. Using appropriate hardening model for material yields acceptable results. Moreover, a convex punch instead of a concave die is used to reach to a higher depth in sheet Electromagnetic Forming.

Full-Text [PDF 488 kb]   (4969 Downloads)    

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb